Hazard Warning Flasher Switch; Eco Mode Switch; Front Fog Light Switch (If So Equipped) - Mitsubishi 2016 Outlander Manual

Hazard warning flasher switch

Hazard warning flasher
switch
5
If you press the flasher switch, the front and
rear turn signals will flash intermittently, and
so will the hazard warning lights. This is an
emergency warning system and should not be
used when the vehicle is in motion, except for
emergencies.
If you need to leave your vehicle, the flashers
will keep working after the ignition switch is
removed or the operation mode is put in OFF.
NOTE
 If the flashers are used for several hours, the
battery will run down. This could make it
difficult or impossible to restart your vehicle.
5-184 Features and controls

ECO mode switch

ECO mode is an eco-driving support system
N00522701328
which automatically controls the engine, air
conditioning system, 4WD system (if so
equipped) and S-AWC (if so equipped) to
improve fuel efficiency.
Refer to Electronically controlled 4WD sys-
tem" on page 5-79.
Refer to "S-AWC (Super-All Wheel Con-
trol)" on page 5-81.
Refer to "Automatic climate control air con-
ditioner" on page 7-5.
The ECO mode starts working by pressing
the ECO mode switch when the ignition
switch or operation mode is in ON.
Push the switch again and the ECO mode will
cancel.
While the ECO mode is working, an ECO
mode indicator will be turned on.
I n f o r ma t i o n P r o v i d e d b y :
NOTE
 Even if the ECO mode is operating, you can
N00579300028
select normal operation of the air condi-
tioner.
For further information, please contact your
authorized Mitsubishi Motors dealer.
Front fog light switch
equipped)
The front fog lights illuminate only when the
headlights are on low beam.
Turning the knob in the direction of the "ON"
position turns on the front fog lights as well
as the indicator in the instrument cluster. To
turn them off, turn the knob in the direction of
the "OFF" position.
The knob will return to the neutral position
when it is released.
(if so
N00522801420