Mitsubishi 2016 Outlander Manual page 428

Replacement of light bulbs
CAUTION
 Handle halogen light bulb with care. The gas
inside a halogen light bulb is highly pressur-
ized, so dropping, knocking, or scratching a
halogen light bulb can cause it to shatter.
 Never hold the halogen light bulb with a bare
hand, dirty glove, etc.
The oil from your hand could cause the bulb
to break the next time the headlights are
used.
If the glass surface is dirty, clean it with
alcohol and let it dry completely before
installing the bulb.
9
NOTE
 If you are unsure of how to carry out the
work as required, it is recommended that
these procedures be carried out by an autho-
rized Mitsubishi Motors dealer or a repair
facility of your choice.
 Be careful not to scratch the vehicle body
when removing a light and lens.
9-30 Vehicle care and maintenance
NOTE
 When it rains, or when the vehicle has been
washed, the inside of the lens sometimes
becomes temporarily foggy. This is the same
phenomenon as when window glass mists up
on a humid day, and does not indicate a func-
tional problem.
When the light is switched on, the heat will
remove the fog. However, if water gathers
inside the light, please have it checked by an
authorized Mitsubishi Motors dealer or a
repair facility of your choice.
Bulb capacity
The bulb should only be replaced with a new
bulb with the same rating and type. The type
and rating are listed on the base of the bulb.
I n f o r ma t i o n P r o v i d e d b y :
Outside
Front
Type A
N00943000132
Type B
Type A: Halogen headlights type
Type B: LED headlights type
N00950301987