Table of Contents
Advertisement
Location of rear-view camera
The rear-view camera (A) is in the liftgate, at
the left side of the liftgate handle.
CAUTION
If the camera lens gets dirty, a clear image
cannot be obtained. As necessary, rinse the
lens with clean water and gently wipe with a
clean, soft cloth.
To avoid damaging the camera;
• Do not rub the cover excessively or polish
it by using an abrasive compound.
• Do not disassemble the camera.
• Do not splash hot water directly on the lens.
• Do not spray the camera and its surround-
ings with high-pressure water.
• Make sure that the liftgate is securely
closed when backing up.
Reference lines on the screen
Reference lines and upper surface of the rear
bumper (A) are displayed on the screen.
Red line (B) indicates approximately 20
inches (50 cm) behind the rear bumper.
Two Green lines (C) indicate approxi-
mately 8 inches (20 cm) outside of the
vehicle body.
Short transverse lines (1 to 3) indicate dis-
tance from the rear bumper.
1:
Approximately at the rear edge of the
rear bumper
2:
Approximately 39 inches (100 cm)
3:
Approximately 79 inches (200 cm)
I n f o r ma t i o n P r o v i d e d b y :
Rear-view camera (if so equipped)
CAUTION
The rear-view camera uses a wide-angle
lens. As a result, images and distances shown
on the screen are not exact.
Actual distance may be different from dis-
tance indicated by the lines on the screen,
depending on the loading condition of the
vehicle and road surface condition.
The reference lines for distance and vehicle
width are based on a level, flat road surface.
In the following cases, objects shown on the
screen will appear to be farther off than they
actually are.
• When the rear of the vehicle is weighed
down with the weight of passengers and
luggage in the vehicle. (Case 1)
• When there is an upward slope at the back.
(Case2)
Case 1
A- Actual objects
B- Objects shown on the screen
Features and controls
5
5-125
Advertisement
Chapters
Table of Contents
