Memory Clear; Initial Clear (Status Clear) - Sam4s SPS-300 Programming & Operation Manual

Memory Clear

Initial Clear (Status Clear)

CAUTION: Do not share this information with unauthorized users. Distribute the S Mode
and/or P Mode key only to those you may want to perform this function.
The initial clear function allows you to exit any register activity and return to a beginning or
cleared state. Any transaction that is in progress will be exited and totals for that transaction will not
be updated. You will not lose your programs and settings!
Here are some reasons you may want to perform an initial clear:
•
The register is in an unknown state, and you wish to exit the current program or transaction
without following normal procedures.
•
You have performed a function that includes a compulsory activity and you wish to bypass
the compulsion.
•
An initial clear may be necessary as part of servicing, or troubleshooting.
To Perform an Initial Clear:
1. Turn the power switch located on the right side of the register to the OFF position..
2. Turn the control lock to the PGM position.
3. For All Models (SPS-320/325/340/345), press and hold the button position where the
SUBTOTAL (SUBTL) button is located on the default keyboard layout.
4. While continuing to hold the SUBTOTAL (SUBTL) button, turn the power switch to the
ON position.
5. After the BEEP, release SUBTOTAL (SUBTL) button. The display now shows
INITIAL CLEAR SERVICE.
SAM4S SPS-300 Series Electronic Cash Register AU
↑ SPS-320/340
INITIAL CLEAR SERVICE
↑ SPS-325/345
Getting Started • 21