Descriptor Code Method - Sam4s SPS-300 Programming & Operation Manual

Descriptor Code Method

If you customise your keyboard by covering key locations, or by installing double or quad size keys,
you will need to program descriptors using the descriptor code method.
See Program Mode
DESCRIPTOR BY CODE to Y to use the descriptor code method.
Program Sequence
1. With the cursor pointed at a descriptor field, refer to the Descriptor Code Chart below and
type the code for the first character. Press the decimal "·" key.
2. For each additional character, type the code and press the decimal key. Each character
will be displayed as it is entered.
3. Press ENTER (CASH) when the descriptor is complete.
Program Example
To program the descriptor "APPLE", type:
6
6
Note:
For lower case enter 98 after the descriptor code. For example:
a =
For DOUBLE (wide) characters enter 99 after the descriptor code. For example:
A =
The Descriptor Code Table is on the following page.
SAM4S SPS-300 Series Electronic Cash Register AU
System Option
•
5 8 0
A P
•
9
ENTER
E
6 5 9 8
6 5 9
pg17 (page 17). You must set the option PROGRAM
•
8 0
P
• ENTER
9
ENTER
•
• •
7 6
L
Program Mode Programming • 151