Ethernet (Irc) Status Test; Trouble Shooting - Sam4s SPS-300 Programming & Operation Manual

Ethernet (IRC) Status Test

The SPS-300 Electronic Cash Register has a LAN port built-in for IRC (Inter Register
Communication) operation. An automatic IRC test has been designed during power up procedure.
While power up, you will see "Please Wait ...." on the display, after a while, a ticket will print from
receipt with the IRC test result.
When IRC network is functioning, a "**
ETHERNET LINK SUCCESS!!! **"
will print.
or...
When test result fails, an "**
ETHERNET LINK FAIL!!! **" will
print. This is when the register is either a
Standalone unit, or there is a problem on
the IRC network.

Trouble Shooting

For two unit IRC networks which two registers are linked with a crossover network cable, please
make both units power up at the same time. If test result is fail, please contact your dealer for further
examination.
For IRC network with a switch/router, please reboot all units within IRC network. For the unit(s)
have the fail test result, please contact your dealer for further examination.
NOTE: When IRC Test Result has been fail or connection has been lost, you have to switch the
power off then back on to run the IRC Test again after trying to rectify the problem. Until
the result been successful for all units, the IRC will not work.
SAM4S SPS-300 Series Electronic Cash Register AU
Please Wait ....
Receipt Example:
** ETHERNET LINK SUCCESS!!! **
Receipt Example:
** ETHERNET LINK FAIL!!! **
Operating Instructions • 31