System Option Programming (For V01.011 And Later) - Sam4s SPS-300 Programming & Operation Manual

System Option Programming (for v01.011 and later)

NOTE: If your SPS-300 is loaded with v01.010 or earlier version firmware, please see Appendix
for System Option Screen Images and Reference Information.
Refer to " System Options - Reference Information " to make program entries or changes, press the
ENTER (CASH) key to finalize your change, then ESC (CLEAR) to exit. Default value has been
highlighted in bold print.
1. At the PGM control lock position menu, press 3 for SYSTEM OPTION Programming. The
SYSTEM OPTION pg 1 screen displays:
2. To browse through the options:
•
Press ENTER key to move " " symbol option by option, or
•
press PAGE UP or PAGE DOWN for fast browsing page by page.
3. When reaching the option you want to modify,
•
For STORE NAME programming on pg18 (page18), the keyboard will change to
Program Overlay, enter the character you need up to 8 characters. Or enter Descriptor
Code to make up the description you want.
NOTE: System Option is default to Program Overlay. Please check setting on page 17
•
For numeric programming options, enter the number through numeric pad,
•
For Yes/No programming options, press YES/NO key to toggle between Y and N
BEEPER ACTIVE
RESERVED
CLERK ENTRY
0:PUSH
CLERK ASSIGNED WHEN CLERK KEY
IS PUSHED (1-10)
SECONDS TO ALLOW DRAWER OPEN 30
(0-99)
ALLOW POST TENDER
OPEN DRAWER ON POST TENDER
ALLOW MULTIPLE RECEIPT
172 • Program Mode Programming
BEEPER ACTIVE
RESERVED
CLERK ENTRY
0:PUSH
CLERK ASSIGNED WHEN CLERK KEY
IS PUSHED (1-10)
SYSTEM OPTION
1:CODE
SYSTEM OPTION
SYSTEM OPTION
1:CODE
pg 1
Y CLERK IS Y:POP-UP
N
0 DRAWER NEEDS TO BE SHUT TO
OPERATE
ACTIVATE OPEN DRAWER ALARM
1
pg 3
CASH DECLARATION REQ
BEFORE REPORTS
N MGR CONTROL TO TEND.
NEGATIVE BALANCE
Y ZERO BALANCE
RESET TRANSACTION NO.ON Z RPT N
Y
SAM4S SPS-300 Series Electronic Cash Register AU
pg 1
Y
N
0
1
SYSTEM OPTION
N:STAY-DOWN
SYSTEM OPTION
pg 2
N
Y
N
pg 4
N
N
N