Ram Clear & Memory Allocation - Sam4s ER-900 Series Technical Manual

Ram Clear & Memory Allocation
Memory All Clear
This reset procedure has been carried out at the factory and need only be carried out if
the machines requires resetting back to factory defaults. Further information can be
found in the Service Mode chapter
** Warning this operation will erase all data from the Cash Register.
1. Insert the C key and turn one past PGM position to unmarked S mode.
2. Then power OFF/ON on whilst holding the key shown below.
The display will show the prompt RAM ALL CLEAR
3. Press the Top Left, Bottom Left, Top Right, Bottom Right keys.
4. The register will show RAM ALL CLEAR. Then an <- for each of the 4 key
presses is shown on the display
Please Wait.. displays whilst determining the Rom Version
5. At the LOAD DEFAULT SET prompt,
either Press CASH to load and print the default values.
or
6. Press QTY/TIME to begin entering new values.
7. When prompted with the file name i.e. PLU as shown above.
either Enter the New Value and press CASH
Note : Electronic Journal lines are based on remaining memory, when prompted EJ line press CASH
or
8. At the PRESS CASH TO FINISH prompt press CASH
9. The process is now complete and the preset values printed.
10. Turn to REG Mode, then Enter 1 and press the Clerk No. key to sign on to the system
Memory alloc OK " is shown when completed.
"
Continue as shown below to change the Default values.
Press CASH to bypass and accept the values shown
25