Exception Handler - Panasonic PN28160A Operation Manual

4.9.4. Exception Handler

On the Switch Tools Configuration Menu, pressing "x" opens the Exception Handler screen,
as shown in Fig. 4-9-6. On this screen, you can configure the exception handling operations.
PN28160/PN28160A Local Management System
Switch Tools Configuration -> Exception Handler
Exception Handler:
Exception Handler Mode:
-------------------------------- <COMMAND> -----------------------------------
Enable/Disable E[x]ception Handler
Set Exception Handler [M]ode
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option
Screen Description
Exception Handler Shows the status of exception handler.
The factory default setting is "Disabled."
Enabled
Disabled
Exception Handler Mode Shows the method of exception handler.
Debug Message
System Reboot
Available commands are listed below.
X Enable/disable exception handler.
Press "X." The command prompt changes to "Enable or Disable Exception Handler (E/D)>." Press
"E" to enable the function. Press "D" to disable it.
M Set the method of exception handler.
Press "M." The command prompt changes to "Select Exception Handler Mode (M/R)>." Press
"M" to display a debug message. Press "R" to reboot.
Q Return to the previous menu.
Disabled
Debug Message
Fig. 4-9-6 Exception Handler
Exception handler is enabled.
Exception handler is disabled.
When the Switching Hub detects exception handler, a debug
message is displayed on the console screen.
When the Switching Hub detects exception handler, the system
automatically starts rebooting.
140