Table of Contents
Advertisement
Available commands are listed below.
E
Set the status of loop detection/shut-off function.
Press "E." The command prompt changes to "Enable or Disable Loop Detection (E/D)>." Press
"E" to enable the loop detection/shut-off function. Press "D" to disable it.
I
Press "I." The Loop History Information screen opens.
L
Set the status of loop detection/shut-off function of each port.
Press "L." The command prompt changes to "Select port number to be changed>." Enter a target
port number. Then, the command prompt changes to "Enable or Disable Loop Detection (E/D)>."
Enter "E" to enable the loop detection/shut-off function of each port. Press "D" to disable it.
When entering multiple port numbers, delimit with comma with no space, or hyphenate the continuous
numbers. Enter "0" to apply all ports.
S
Set the status of recovery mode for auto-recovery of the shutoff port.
Press "S." The command prompt changes to "Select port number to be changed>." Enter a target
port number. Then, the command prompt changes to "Enable or Disable Recovery for port x (E/D)>."
Press "E" to enable auto-recovery of the port. Press "D" to disable it.
When entering multiple port numbers, delimit with comma with no space, or hyphenate the continuous
numbers. Enter "0" to apply all ports.
T
Set the recovery time in seconds, which is the standby time until the shutoff port is automatically recovered.
Press "T." The command prompt changes to "Select port number to be changed>." Enter a target
port number. Then, the command prompt changes to "Enter Recovery Timer>." Enter the recovery
time in seconds from 60 to 86400.
Q
Return to the previous menu.
Note:
If the status of loop detection/shut-off function (Global Loop Detection Status) is
changed, the configuration information is saved and all settings are stored in a built-in
memory.
118
Advertisement
Table of Contents
