Table of Contents
Advertisement
4.6.7.d. LED Base Mode Configuration
On the System Security Configuration, pressing "B" opens the LED Base Mode Configuration
screen, as shown in Fig. 4-6-15. On this screen, you can configure the LED base mode
setting.
PN28160/PN28160A Local Management System
System Security Configuration -> LED Base Mode Configuration
System LED base-mode: Status
Note: Save Configuration to Flash will be executed when LED Base Mode changed.
-------------------------------- <COMMAND> -----------------------------------
Set LED [B]ase Mode
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option
Screen Description
System LED
Shows the current LED base mode.
base-mode
This is set to the status mode (Status) on shipment.
Status
Eco
Available commands are listed below.
B
Change the LED base mode.
Press "B." The command prompt changes to "Select LED Base Mode (S/E)>." Press "S" to change
the LED base mode to the status mode. Press "E" to change it to the ECO mode.
Q
Return to the previous menu.
Note:
If the LED base mode is changed, the configuration information is saved and all settings
are stored in a built-in memory.
Fig. 4-6-15 LED Base Mode Configuration
Operating in status mode.
Operating in ECO mode.
61
Advertisement
Table of Contents
