Table of Contents
Advertisement
Available commands are listed below.
N
Show the values of the next port.
Press "N." The screen shows the counter values of the next port. Disabled in Port 16.
P
Show the values of the previous port.
Press "P." The screen shows the counter values of the previous port. Disabled in Port 1.
S
Switch a target port.
Press "S." The command prompt changes to "Select Port number>." Enter the port number you
wish to display.
F
Set the screen refresh mode.
Press "F." The command prompt changes to "1 for start to refresh, 2 for set refresh rate." Press
"1" to stop auto-refresh. Press "2" to change the refresh interval.
If you press "2," the command prompt changes to "Input refresh time>." Enter an integer between
5 and 600 (seconds).
R
Reset counter values.
Press "R" to reset counter values. The display is changed at the counter reset.
Q
Return to the previous menu.
128
Advertisement
Table of Contents
