Panasonic PN28160A Operation Manual page 113

4.7.5.b. Egress Rate Limiting Configuration Menu
On the Quality of Service Configuration Menu, pressing "C" opens the Egress Rate Limiting
Configuration Menu, as shown in Fig. 4-7-23. On this screen, you can set bandwidth control.
PN28160/PN28160A Local Management System
Quality of Service Configuration -> Egress Rate Limiting Configuration Menu
Port Bandwidth
---- ----------- --------
1 1000
2 1000
3 1000
4 1000
5 1000
6 1000
7 1000
8 1000
9 1000
10 1000
11 1000
12 1000
Note: Bandwidth - 1Mbps/unit
-------------------------------- <COMMAND> -----------------------------------
[N]ext Page
[P]revious Page
Set [B]andwidth
Command>
Enter the character in square brackets to select option
Fig. 4-7-23 Egress Rate Limiting Configuration Menu
Screen Description
Port
Bandwidth
Status
Available commands are listed below.
N Show the next page.
Press "N." The screen shows the next page.
P Show the previous page.
Press "P." The screen shows the previous page.
B Set a bandwidth.
Press "B." The command prompt changes to "Enter port number e.g.: 1, 3, 5-8>." Enter
a port number to designate. Then, the command prompt changes to "Enter bandwidth>." Enter
a value between 1 and 1000.
S Set the bandwidth control.
Press "S." The command prompt changes to "Enter port number e.g.: 1, 3, 5-8>." Enter
a port number to designate. Then, the command prompt changes to "Enable or Disable Status
(E/D)>." Press "E" to enable the bandwidth control. Press "D" to disable it.
Q Return to the previous menu.
Status
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Set [S]tatus
[Q]uit to previous menu
Shows the port number.
Shows the bandwidth. The factory default setting is 1000. (Unit is Mbps.)
Enables/disables the bandwidth control.
Enabled Bandwidth control is enabled.
Disabled Bandwidth control is disabled.
113