Available commands are listed below.
A
Enable/disable the trap sending at an SNMP authentication failure.
Press "A." The command prompt changes to "Enable or Disable SNMP Authentication trap (E/D)>."
Press "E" to enable the trap sending. Press "D" to disable it.
L
Enable/disable the trap sending at a login failure.
Press "L." The command prompt changes to "Enable or Disable Login failure trap (E/D)>." Press
"E" to enable the trap sending. Press "D" to disable it.
P
Add a port to which the trap is sent when its link status changes.
Press "P." The command prompt changes to "Enter port number>." Enter a port number. The trap
is sent for this port.
D
Delete a port to which the trap is sent when its link status changes.
Press "D." The command prompt changes to "Enter port number>." Enter a port number. The trap
is not sent for this port.
Q
Return to the previous menu.
Note:
There is no individual configuration item for loop detection trap. They are sent based
on the SNMP Trap Receiver Configuration.
42