Table of Contents
Advertisement
Screen Description
Entry
Shows the event number.
Time
Shows the time when the event occurred. If the time is not set, the accumulated running time
since boot is shown.
Event
Shows the description of the event occurred to the Switching Hub.
Available commands are listed below.
N
Show the next page.
Press "N." The screen shows the next page.
P
Show the previous page.
Press "P." The screen shows the previous page.
C
Clear all logs.
Press "C" to clear all logs.
Q
Return to the previous menu.
System logs are as follows.
ARL
Memory allocation fail!
err
Indicates that allocation of memory for MAC address table has failed.
CLI
Get reboot timer fail.
warn
Indicates that the operation of reboot timer has failed.
Reboot: Factory Default Except IP.
Indicates that the Switching Hub was rebooted in the mode to return settings other than
IP addresses to the factory default.
Reboot: Factory Default.
info
Indicates that the Switching Hub was rebooted in the mode to return all settings to the factory
default.
Reboot: Normal.
Indicates that the Switching Hub was rebooted.
CONSOLE
Login from console
info
Indicates that the login operation was executed via console, and was successful.
LINE-PROTOCOL
PortX auto recovery.
Indicates that Port X has auto-recovered from shutoff after loop detection.
The loop detected between portA and portB.
info
Indicates that a loop was detected between Port A and Port B.
The loop detected on portX.
Indicates that a loop was detected on Port X.
PORT
err
PortX hardware register set fail in port initialization!
144
Advertisement
Table of Contents
