Table of Contents
Advertisement
Screen Description
Port
Shows the port number.
Link
Shows the current link status.
Up
Down
Trunk
Shows the group number for a trunked port.
Type
Shows the port type.
100TX
1000T
1000X
Mode
Shows the communication speed and full-duplex/half-duplex settings. The factory default setting
is "Auto" for all ports.
Auto
100-FDx(100F)
100-HDx(100H)
10-FDx(10F)
10-HDx(10H)
Power-
Shows status of the MNO series power saving mode.
saving
The factory default setting is "Half" for all ports.
Half
Full
Disabled
Available commands are listed below.
N
Show the next page.
Press "N." The screen shows the next port.
P
Show the previous page.
Press "P." The screen shows the previous port.
S
Set the MNO series power saving mode.
Press "S." The command prompt changes to "Select port number to be changed>." Enter a port
number you wish to change. Press "0" to change the settings of all ports at a time. Then, the command
prompt changes to "Enter Power Saving mode for port (F/H/D)>." Press "E" to enable the mode.
Press "D" to disable it. Press "H" to enable the power saving mode of giving priority to connectivity
with another device. As the change is applied, the display on the screen is updated automatically.
Q
Return to the previous menu.
Link is established successfully.
Link is not established.
The port type is 10/100BASE-TX.
The port type is 10/100/1000BASE-T.
The port type is SFP extension port.
Auto negotiation mode
100 Mbps full-duplex
100 Mbps half-duplex
10 Mbps full-duplex
10 Mbps half-duplex
Power saving mode is enabled (Half).
Power saving mode is enabled (Full).
Power saving mode is disabled.
51
Advertisement
Table of Contents
