Table of Contents
Advertisement
Screen Description
Monitoring Port
Shows the destination port number of data to be monitored.
Be Monitored Port(s)
Shows the target port number to be monitored.
Direction
Shows the communication direction of target packet to be monitored.
Tx
Rx
Both
Status
Shows the status of port monitoring.
Enabled
Disabled
Available commands are listed below.
S
Set a destination port of data to be monitored (port to which analyzer, etc. is connected).
Press "S." The command prompt changes to "Enter port number>." Enter a target port number.
M
Set a port to be monitored.
Press "M." The command prompt changes to "Enter port number>." Enter a target port number.
When entering multiple port numbers, delimit with comma with no space, or hyphenate the continuous
numbers.
D
Set a communication direction of target packet to be monitored.
Press "D." The command prompt changes to "Select port monitoring direction (R/T/B)>." Enter
"R" to monitor a receive packet. Enter "T" to monitor a transmit packet. Enter "B" to monitor both
receive and transmit packets.
C
Set the status of port monitoring.
Press "C." The command prompt changes to "Enter the select(E/D)>." Enter "E" to start monitoring.
Enter "D" to stop monitoring.
Q
Return to the previous menu.
Note:
VLAN tag of received VLAN ID is attached to a mirror packet in Tx-direction.
Note:
Management packets including Ping and ARP sent from this Switching Hub cannot
be captured.
Monitors a transmit packet.
Monitors a receive packet.
Monitors both transmit and receive packets. (Factory default setting)
Port monitoring is enabled.
Port monitoring is disabled. (Factory default setting)
86
Advertisement
Table of Contents
