Table of Contents
Advertisement
Available commands are listed below.
C
Configure the idle timeout settings for automatically terminating a console-connected session if no input
is made.
Press "C." The command prompt changes to "Enter console idle timeout>." Enter a value from 0
to 60 (minutes). Entering "0" disables the automatic termination.
T
Configure the idle timeout settings for automatically terminating a Telnet-connected session if no input is
made.
Press "T." The command prompt changes to "Enter telnet idle timeout>." Enter a value from 1 to
60 (minutes).
N
Edit the login user name.
Press "N." The command prompt changes to "Enter current password>." Enter the current password.
After entering the correct password, the command prompt changes to "Enter new name>." Enter a
new user name in 12 one-byte characters.
P
Edit the login password.
Press "P." The command prompt changes to "Enter old password>." Enter the current password.
After entering the correct password, the command prompt changes to "Enter new password>." Enter
a new password in 12 one-byte characters. After entering the password, the command prompt changes
to "Retype new password>" for confirmation. Enter the new password again.
L
Configure the Telnet access settings.
Press "L." The command prompt changes to "Enable or Disable telnet server(E/D)>."
Press "E" to enable the access. Press "D" to disable the access.
S
Configure the SNMP access settings.
Press "S." The command prompt changes to "Enable or Disable SNMP Agent(E/D)>."
Press "E" to enable the access. Press "D" to disable the access.
R
Configure the RADIUS server access settings for login authentication.
Press "R." The RADIUS Configuration Menu opens. For configuration details, refer to the next section
(4.6.7.b).
A
Set Telnet accessible terminals.
Press "A." The Telnet Access Limitation Menu opens. For configuration details, refer to the next section
(4.6.7.a).
I
Configures the access settings for the IP address configuration software, bundled with the Panasonic network
cameras.
Press "I." The command prompt changes to "Enable or Disable IP setup interface (E/D)>."
Press "E" to enable the access. Press "D" to disable the access.
O
Set the verification method of the login user name and password.
Press "O." The command prompt changes to "Enter manager entry number>." Press "1" to change
the first login method. Press "2" to change the second login method. Then, the command prompt
changes to the "Select the login method." Press "L" to use the user name and password set in
the Switching Hub. Press "R" to use authentication by RADIUS. Press "N" for no setting.
H
Configure the SSH server settings.
Press "H." The SSH Server Configuration Menu opens. For configuration details, refer to the next
section (4.6.7.c).
B
Configure the LED base mode settings.
Press "B." The LED Basic Mode Configuration Menu opens. For configuration details, refer to the
next section (4.6.7.d).
Q
Return to the previous menu.
54
Advertisement
Table of Contents
