Table of Contents
Advertisement
Available commands are listed below.
C
Set the time of internal clock of this Switching Hub.
Press "C." The command prompt changes to "Enter Date(Year) >" and enter a year. Then, the
command prompt changes to "Enter Date(Month) >" and enter a month. Then, the command prompt
changes to "Enter Date(Day) >" and enter a day. Then, the command prompt changes to "Enter
Time(Hour) >" and enter an hour. Then, the command prompt changes to "Enter Time(Minute)
>" and enter a minute. Then, the command prompt changes to "Enter Time(Sec) >" and enter
a second.
P
Set an IP address of SNTP server.
Press "P." The command prompt changes to "Enter new IP address>." Enter an IP address of SNTP
server.
I
Set an interval of time synchronization with SNTP server.
Press "I." The command prompt changes to "Enter Interval Time>." Enter an interval of time synchronization
with SNTP server with a value of 1 to 1440 (minutes).
The factory default setting is 1440 minutes (1 day).
E
Set the application status of Daylight Saving (Summer time).
Press "E." The command prompt changes to "Enable or Disable Daylight Saving (E/D)>." Enter
"E" to use daylight saving time. Press "D" not to use it.
When the time zone is set to where daylight saving time is not applied, this setting is not available.
When this Switching Hub is used domestically, this setting is not required.
Z
Set the time zone.
Press "Z." A list of time zones is displayed. Specify a time zone you wish to set.
When this Switching Hub is used domestically, change of time zone is not required as the factory
default setting is "(GMT+09:00) Osaka, Sapporo, Tokyo."
Q
Return to the previous menu.
Note:
If SNTP server is located outside of firewall, connection with SNTP server may be
blocked depending on settings by a system administrator.
For details, ask your system administrator.
If you wish to disable time synchronization function, set SNTP server IP to 0.0.0.0.
69
Advertisement
Table of Contents
