Table of Contents
Advertisement
Available commands are listed below.
S
Enable/disable the trap receiver.
Press "S." The command prompt changes to "Enter manager entry number>." Enter an entry number
for the trap receiver you wish to configure. Then, the command prompt changes to "Enable or Disable
Trap Receiver (E/D)>." Press "E" to enable the SNMP manager. Press "D" to disable it.
I
Set an IP address for the trap receiver.
Press "I." The command prompt changes to "Enter manager entry number>." Enter an entry number
for the trap receiver you wish to configure. Then, the command prompt changes to "Enter IP address
for trap receiver>." Enter an IP address.
D
Configure the trap sending settings when the link status changes.
Press "D" to open the Enable/Disable Individual Trap Menu.
For configuration details, refer to 4.6.3.C.
T
Set a trap type.
Press "T." The command prompt changes to "Enter manager entry number>." Enter an entry number
for the trap receiver you wish to configure. Then, the command prompt changes to "Enter the selection>."
Press "1" to select SNMPv1 traps. Press "2" to select SNMPv2 traps.
C
Set a community name for the trap receiver.
Press "C." The command prompt changes to "Enter manager entry number>." Enter an entry number
for a trap receiver you wish to configure. Then, the command prompt changes to "Enter community
name for trap receiver>." Enter a community name.
Q
Return to the previous menu.
40
Advertisement
Table of Contents
