1
.
5
.
L
E
D
D
i
s
p
l
a
1
.
5
.
L
E
D
D
i
s
p
l
a
1.5.1. Setting LED Base Mode
You can select display of LEDs in this Switching Hub from two types: Status mode and Eco
mode.
The mode selected at system start-up is called the base mode. The base mode can be switched
by keeping pressing the LED display switch button for more than 3 seconds. After pressing
the LED display switch button for more than 3 seconds, STATUS/ECO, GIGA, 100M, and
FULL LEDs will turn on at once, and then the mode will switch over.
Status mode (Factory default setting)
According to the port LED display mode, port LED shows the status of each port. In status
mode, STATUS/ECO LED lights in green.
ECO mode
Regardless of whether a device is connected or not, all LEDs other than POWER and
STATUS/ECO LEDs turn off to save power. In ECO mode, STATUS/ECO LED flashes in green.
The base mode can be set from the configuration menu of this Switching Hub. For details,
refer to 4.6.7.c.
1.5.2. LED Display Switchover
By pressing the LED display switch button on the front panel, display of port LED can be
changed in the following order.
Port LED display mode
STATUS/ECO
GIGA
100M
FULL
LOOP HISTORY
If the port LED display mode is switched to other than STATUS/ECO and then no operation
is executed for more than 1 minute, the mode automatically shifts to the base mode.
y
C
h
a
n
g
e
B
u
t
t
o
n
y
C
h
a
n
g
e
B
u
t
t
o
Shows link establishment and communication status.
Shows linkup status at 1000 Mbps.
Shows linkup status at 100 Mbps.
Shows linkup status at full-duplex or half-duplex.
Shows loop detection and port shut-off status.
14
n
Description