Table of Contents
Advertisement
Available commands are listed below.
S
Set the SNMP manager status.
Press "S." The command prompt changes to "Enter manager entry number>." Enter an SNMP manager
entry number you wish to configure. Then, the command prompt changes to "Enable or Disable SNMP
manger (E/D)>." Press "E" to enable the SNMP manager. Press "D" to disable it.
I
Set an IP address for an SNMP manager.
Press "I." The command prompt changes to "Enter manager entry number>." Enter an SNMP Management
entry number you wish to configure. Then, the command prompt changes to "Enter IP address for manager>."
Enter an IP address.
R
Set an access privilege for an SNMP manager.
Press "R." The command prompt changes to "Enter manager entry number>." Enter an SNMP manager
entry number you wish to configure. Then, the command prompt changes to "Enter the selection>."
Press "1" for read-only permission. Press "2" for read-and-write.
C
Set a community name for an SNMP manager.
Press "C." The command prompt changes to "Enter manager entry number>." Enter an SNMP manager
entry number you wish to configure. Then, the command prompt changes to "Enter community name
for manager>." Enter a community name.
Q
Return to the previous menu.
38
Advertisement
Table of Contents
