Panasonic PN28160A Operation Manual page 56

Available commands are listed below.
E Enable/Disable the access limitation from Telnet.
E Set the access limitation from Telnet to Enable.
D Set the access limitation from Telnet to Disable.
A Set an IP address to be permitted. Five ranges can be set up.
Press "A." The command prompt changes to "Enter IP address entry number>." Enter an IP address
entry number between 1 and 5. The command prompt changes to "Enter IP address>." Enter an
IP address to be permitted. If IP address is correct, the command prompt changes to "Enter subnet
mask>." Enter a range of IP address you wish to permit accessing with mask.
(Setting example)
No. IP Address
----- --------------------
----------------------------------------------------
1 192.168.1.10
2 192.168.1.20
3 192.168.2.1
4 192.168.3.1
D Delete a range of IP address that has been set up.
Press "D." The command prompt changes to "Enter IP address entry number>." Enter an IP address
entry number you wish to delete.
M Change a range of IP address that has been set up.
Press "M." The command prompt changes to "Enter IP address entry number>." Enter an IP address
entry number between 1 and 5. The command prompt changes to "Enter IP address>." Enter an
IP address that has been set up. The command prompt changes to "Enter subnet mask>." Enter
a range of IP address you wish to permit accessing with mask.
Q Return to the previous menu.
Subnet Mask Access permitted IP address
--------------------------
255.255.255.255 192.168.1.10
(Only one unit can be accessed)
255.255.255.254 192.168.1.20, 192.168.1.21
(Two units can be accessed)
255.255.255.128 192.168.2.1 – 192.168.2.127
(127 units can be accessed)
255.255.255.0 192.168.3.1 – 192.168.3.254
(254 units can be accessed)
56