Table of Contents
Advertisement
4. Configuration
Upon power on, this Switching Hub starts working as a switching hub. To use the SNMP
management functionality or other unique functions, you need to configure the Switching Hub
using a console port, Telnet, or SSH.
In this chapter, the configuration of this Switching Hub is explained.
Note:
You need to configure an IP address to access this Switching Hub via Telnet or SSH.
Therefore, configure an IP address first via the console port, before accessing via Telnet
or SSH.
4
.
1
.
C
o
n
n
e
c
t
i
n
g
4
.
1
.
C
o
n
n
e
c
t
i
n
g
Console connection requires a DEC VT100-compatible asynchronous terminal, or a terminal
capable of running a VT100-compatible terminal emulator, such as HyperTerminal on Windows
XP or older. Connect a terminal of this kind to the console port of this Switching Hub.
Configure the communication mode for the asynchronous terminal as follows:
Transmission mode:
Emulation mode:
Transmission speed:
Data length:
Stop bit:
Parity control:
Flow control:
If you are using a Windows machine before Windows XP, refer to "Appendix B. Procedures
for Console Port Connection using Windows HyperTerminal."
v
i
a
C
o
n
s
o
l
e
P
o
r
v
i
a
C
o
n
s
o
l
e
P
o
r
RS-232C (ITU-TS V.24 compatible)
VT100
9600 bps
8 bit
1 bit
None
None
20
t
t
Advertisement
Table of Contents
