Available commands are listed below.
I
Set/edit the IP address.
Press "I." The command prompt changes to "Enter IP address>." Enter an IP address for the Switching
Hub.
M
Set/edit the subnet mask.
Press "M." The command prompt changes to "Enter subnet mask>." Enter a subnet mask for the
Switching Hub.
G
Set/edit the IP address of the router for the default gateway.
Press "G." The command prompt changes to "Enter new gateway IP address>." Enter the IP address
of the router, set as the default gateway.
A
Set the IP address, subnet mask and default gateway in succession.
Press "A." The command prompt changes to "Enter IP address>." Enter the IP address of the Switching
Hub. Then, the command prompt changes to "Enter subnet mask>." Enter the subnet mask. Then,
the command prompt changes to "Enter new gateway IP address>." Enter the IP address of a router,
used as a default gateway.
Q
Return to the previous menu.
Note:
This item must be set in order to use the SNMP management functionality and to
enable a remote connection by Telnet or SSH. Any IP addresses on the local network
must be unique and no duplication is allowed. If you are unsure, consult the network
administrator.
34