Table of Contents
Advertisement
4.9.3. System Reboot
On the Switch Tools Configuration Menu, pressing "R" opens the System Reboot Menu, as
shown in Fig. 4-9-5. On this screen, you can reboot this Switching Hub.
PN28160/PN28160A Local Management System
Switch Tools Configuration -> System Reboot Menu
Reboot Status:
Reboot Type:
Reboot Timer:
Time Left:
-------------------------------- <COMMAND> -----------------------------------
Set Reboot [O]ption
Start [R]eboot Process
Set Reboot [T]imer
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option
Screen Description
Reboot Status
Shows whether or not the reboot command is being executed.
Stop
Reboot Type
Shows the reboot type. The factory default setting is "Normal."
Normal
Factory Default
Factory Default
Except IP
Reboot Timer
Shows the time between execution of the reboot command and actual reboot. The
factory default setting is 0 seconds.
Time Left
Shows the time left before the system actually reboots after execution of the reboot
command. A key entry refreshes the screen display, allowing you to check the elapsed
time.
Stop
Normal
0 seconds
N/A
Fig. 4-9-5 System Reboot
Indicates that the reboot command is not being executed.
Normal reboot is executed.
All settings are reset to factory default.
All settings except the IP address are reset to factory default.
138
Advertisement
Table of Contents
