Panasonic PN28160A Operation Manual page 76

Press "I." The command prompt changes to "Enable or Disable Internet Mansion Function? (E/D)>."
Press "E" to enable the function. Press "D" to disable it. If "E" is selected, the command prompt
changes to "Uplink port?>." Enter a port number you wish to configure as an uplink port.
This function enables to configure all settings needed for the Internet mansion environment. Ports other
than that designated as an uplink port are set as downlink ports. Communications between downlink
ports are shut off. Therefore, it becomes possible to ensure security between each resident.
(There are some constrained conditions for use. Please make configuration after confirming the notes.)
O Go to the screen for changing VLAN.
Press "O." The command prompt changes to "Enter VLAN ID>." Enter a VLAN ID you wish to configure
with a value of 1 to 4094. Then, the VLAN Modification Menu opens. For details, refer to the next
section (4.7.1.d).
S Set and confirm PVID by port.
Press "S." The VLAN Port Configuration Menu opens. For details, refer to the next section (4.7.1.e).
Q Return to the previous menu.
Note: VLAN 1 is set on shipment, and all ports belong to this VLAN.
Also, the management VLAN is enabled.
Note: When creating a new VLAN, PVID (after-mentioned) is not changed in conjunction
with this new creation. After registering VLAN on this screen, make sure to confirm
the configuration operation and content on the configuration screen in Fig. 4-7-4 and
Fig. 4-7-5.
On deletion, you cannot delete a VLAN whose ID is remained as a PVID. Delete the
VLAN after changing the PVID to another ID.
Note: When Internet Mansion mode is enabled, there are constrained conditions as the followings.
Please use the Switching Hub after confirming these constrained conditions.
(1) Combined usage with Link Aggregation is not possible.
(2) Static registration to MAC Address table is not possible.
(3) Combined usage with MAC Learning is not possible.
(4) Only the uplink port belongs to management VLAN.
76