Table of Contents
Advertisement
2.1 LED display change
●Display style set by the LED display change button
Indication on the front panel and
LED lamps
You can display the following items using the LED display change button.
Display for the connection with a connected terminal (Status mode),Display for
the 1000 Mbps transmission rate (GIGA mode),Display for the 100Mbps or 10
Mbps transmission rate (Speed mode),Display for the full-duplex or half-duplex
transmission system (DUPLEX mode),Display for ports with a loop history (Loop
history mode),All port LED lamps can be turned OFF (ECO mode).
●Two types of Base modes and each mode
The mode at the start is called "Base mode."
There are two types of Base modes:Status mode (factory default setting) and ECO
mode.You can change the Base mode by holding down the LED display change
button (for at least 3 sec).
When the Base mode is changed normally,all STATUS/ECO,GIGA,100M,and FULL
LED lamps light up at the same time.When you release the button,the Base mode is
changed to the selected mode.
If the mode is changed to the GIGA mode,Speed mode,DUPLEX mode,or loop
history mode and the LED display change button is not used for one minute or
longer,the mode automatically returns to a Base mode (Status mode or ECO mode).
The Base mode is maintained even after the power is turned OFF.
1
Switch-M16eG
POWER
LED DISPLAY
ANY COL.
CHANGE BUTTON
STATUS/ECO
KEEP PRESSING 3SEC
ECO MODE ON/OFF
GIGA
100M
FULL
LOOP HISTORY
2
LED display change button
RIGHT LED(ORANGE):LOOP DETECTION
SFP
£
3
5
7
9
11
13
15
CONSOLE
9600.N.8.1(DTE)
4
6
8
10
12
14
16
SFP
¥
13
Advertisement
Table of Contents
