Led Display Change - Panasonic PN290496-NZ Installation Manual

2.1 LED display change

●Display style set by the LED display change button
Indication on the front panel and
LED lamps
You can display the following items using the LED display switch button.
Display for the connection with a connected terminal (Status mode),
Display for the 10 Gbps transmission rate (10G mode),
Display for the 5 Gbps transmission rate (5G mode),
Display for the 2.5 Gbps transmission rate (2.5G mode),
Display for the 1000 Mbps transmission rate (1G mode),
Display for ports with a loop history (Loop history mode),
All port LED lamps can be turned OFF (ECO mode).
●Two types of Base modes and each mode
The mode at the start is called "Base mode."
There are two types of Base modes:Status mode (factory default setting) and ECO
mode.You can change the Base mode by holding down the LED display switch
button (for at least 3 sec).
When the Base mode is changed normally,all STATUS/ECO,10G,5G,2.5G,and 1G LED
lamps light up at the same time.When you release the button,the Base mode is changed
to the selected mode.
If the mode is changed to the 10G mode,5G mode,2.5G mode,1G mode,or loop history
mode and the LED display switch button is not used for one minute or longer,the mode
automatically returns to a Base mode (Status mode or ECO mode).
The Base mode is maintained even after the power is turned OFF.
LED display change button
15