Cruise Control
Actuator Cable Adjustment
1. Check that the actuator cable (A) moves smoothly
w i t h no binding or sticking.
Measure the amount of m o v e m e n t of the output
linkage (B) until the engine speed starts to increase.
At first, the output linkage should be located at the
fully closed position (C). The free play (D) should be
3.75 + 0.5 m m (0.15 + 0.02 in.).
If the free play is not w i t h i n specs, move the cable
to the point where the engine speed starts t o
increase, and tighten the locknut (A) and adjusting
nut (B).
< 3 d
4. Turn the adjusting nut (B) until it is 3.75 ± 0 . 5 m m
(0.15 + 0.02 in.) away f r o m the bracket (C).
3 . 7 5 ± 0 . 5 m m ( 0 . 1 5 ± 0 . 0 2 in.)
B
5. Pull the cable so that the adjusting nut (B) touches
the bracket, and tighten the locknut (A).
4-54