9-2] Network Data Transmission - Panasonic KX-TDA100 Programming Manual

2.15.2 [9-2] Network Data Transmission

Settings related to the transmission of extension BLF (Busy Line Field) data or Message Waiting
notifications over a network of PBXs can be programmed.
Extension BLF data is used to show the status of a monitored extension attached to another PBX on
a Network DSS (NDSS) button. Network Message Waiting notifications are used for the Centralised
VM feature, and a VPS can send notifications to extensions connected to any PBX in the network.
Network BLF Data Transmission for Centralised Operator Feature—Network
PBX ID
Specifies the Network ID of the PBX, for Network Direct Station Selection (NDSS). This parameter
must be set in correspondence with the Network IDs assigned to other PBXs in the network.
Network IDs 1-8 can only be assigned to one PBX each within a network. Assigning the same
Network ID to two PBXs will cause network data transmission problems.
Changing this value in Interactive mode will automatically clear any NDSS Link Data.
Value Range
0: The PBX retransmits BLF data sent by other PBXs.
1: The PBX receives BLF data sent by other PBXs.
2–8: The PBX transmits BLF data over the network.
Maintenance Console Location
2.15.2 [9-2] Network Data Transmission
Programming Manual References
None
Feature Guide References
1.30.5.1 Network Direct Station Selection (NDSS)
Network BLF Data Transmission for Centralised Operator Feature—Data
Transmission VoIP->ISDN
Selects whether to re-send BLF data received from a VoIP port through any ISDN ports that are set
to transmit BLF data.
Value Range
Disable, Enable
Maintenance Console Location
2.15.2 [9-2] Network Data Transmission
Programming Manual References
2.7.14 [1-1] Slot—BRI Port—ISDN CO—Networking Data Transfer
2.7.16 [1-1] Slot—PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)—CO Setting—Networking
Data Transfer
2.15 [9] Private Network
PC Programming Manual 741