2.7 [1] Configuration
Feature Guide References
None
Flash—Flash Width (OPX)
Specifies the maximum length of a flash signal sent from an SLT connected to an OPX that the PBX
can recognise as a hookswitch flash signal.
Value Range
8 × n (n=3–191) ms
Maintenance Console Location
2.7.18 [1-1] Slot—T1 Card Property (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
None
Feature Guide References
None
Flash—Flash Signal Detection (TIE)
Enables the PBX to detect a hookswitch flash signal sent from a TIE line.
Value Range
Disable, Enable
Maintenance Console Location
2.7.18 [1-1] Slot—T1 Card Property (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
None
Feature Guide References
None
Flash—Minimum BREAK Width (TIE)
Specifies the minimum length of the break signal in a flash signal sent from a TIE line.
Value Range
8 × n (n=3–63) ms
Maintenance Console Location
2.7.18 [1-1] Slot—T1 Card Property (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
None
222
PC Programming Manual