1-1] Slot-Ip-Extension Port (Kx-Tda100/Kx-Tda200/Kx-Tda600 Only) - Panasonic KX-TDA100 Programming Manual

2.7.38 [1-1] Slot—IP-Extension Port (KX-TDA100/KX-TDA200/KX-
TDA600 only)
Various settings can be programmed for each IP extension port.
To change the status of extension ports, click Command.
IP-PT Registration and De-registration
An IP-PT must be registered to the PBX by programming both the PBX and IP-PT before it can be
used. Programming instructions of the PBX are given below.
It is possible to de-register the IP-PT later.
Preparation
Follow the steps below to prepare before registering an IP-PT.
1.
Open 2.7.36 [1-1] Slot—IP-Extension Card Property (KX-TDA100/KX-TDA200/KX-
TDA600 only), and confirm that the IP address and subnet mask settings of the IP-EXT16
card are correct.
2.
Open 2.7.37 [1-1] Slot—IP-Extension Card Property—Common Settings (KX-TDA100/
KX-TDA200/KX-TDA600 only) (MPR Software File Version 3.1000 or later) (MPR
Software File Version 3.1000 or later) or 2.8.21 [2-12] IP Extension Settings (KX-TDA100/
KX-TDA200/KX-TDA600 only) (not available for MPR Software File Version 3.1000 or
later) (all other versions), and set the gateway address.
Registration
Follow the steps below to register the IP-PT.
1.
Connect the IP-PT to be registered to the network and, if necessary, the power supply.
2.
Click Registration.
A dialog box will appear. Non-registered (available) extension numbers are displayed on the
left.
3.
Highlight numbers and click the right arrow to select them for registration. Click Next.
A screen will appear with information on the current IP-PT extension number and index
number for programming.
4.
Programme the relevant IP-PT.
5.
Click Next.
•
•
Once the IP-PT is successfully registered, the status of the IP-PT will update to show
"Registered".
De-registration
Follow the steps below to de-register the IP-PT.
1.
Click De-registration.
A dialog box will appear. Registered extension numbers are displayed on the left.
If the registration is still in process, the dialog box will show "Waiting for IP-PT to
register...". Click OK.
If the registration is successful, the dialog box will show "Registration Succeed".
If there are more IP-PTs to be registered, click Continue to resume or Cancel to
terminate the registration. If not, click Close.
2.7 [1] Configuration
PC Programming Manual 313