9-2] Network Data Transmission - Panasonic KX-TDE100 Pc Programming Manual

11.2 [9-2] Network Data Transmission

11.2 [9-2] Network Data Transmission
Settings related to the transmission of extension BLF (Busy Line Field) data or Message Waiting notifications
over a network of PBXs can be programmed.
Extension BLF data is used to show the status of a monitored extension attached to another PBX on a Network
DSS (NDSS) button. Network Message Waiting notifications are used for the Centralised VM feature, and a
VPS can send notifications to extensions connected to any PBX in the network.
Network Data Transmission for Centralised Operator Feature—Network PBX ID
Specifies the Network ID of the PBX, for Network Direct Station Selection (NDSS). This parameter must be
set in correspondence with the Network IDs assigned to other PBXs in the network.
Network IDs 1-8 can only be assigned to one PBX each within a network. Assigning the same Network ID to
two PBXs will cause network data transmission problems.
Changing this value in Interactive mode will automatically clear any NDSS Link Data.
Value Range
0: The PBX retransmits BLF data sent by other PBXs.
1: The PBX receives BLF data sent by other PBXs.
2–8: The PBX transmits BLF data over the network.
Maintenance Console Location
11.2 [9-2] Network Data Transmission
Programming Manual References
None
Feature Guide References
1.30.5.1 Network Direct Station Selection (NDSS)
Network Data Transmission for Centralised Operator Feature—Data
Transmission VoIP->ISDN
Selects whether to re-send BLF data received from a VoIP port through any ISDN ports that are set to transmit
BLF data.
Value Range
Disable, Enable
Maintenance Console Location
11.2 [9-2] Network Data Transmission
Programming Manual References
3.30 [1-1] Slot—Port Property - BRI Port—ISDN CO—
3.32 [1-1] Slot—Port Property - PRI Port—CO Setting—
864 PC Programming Manual
Networking Data Transfer
Networking Data Transfer