Panasonic KX-TDA100 Programming Manual page 212

2.7 [1] Configuration
Feature Guide References
None
Connection
Indicates the port status (reference only).
This column offers two ways to open the screen to select the port command:
• Click the desired cell in the column.
• Select the desired cell in the column, and then click Command.
Value Range
INS: The port is in service.
OUS: The port is out of service.
Fault: The port is not communicating with the network.
Maintenance Console Location
2.7.16 [1-1] Slot—PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
None
Feature Guide References
None
COLP, CLIR, COLR, CNIP, CONP, CNIR, CONR, CF (Rerouting), CT, CCBS,
AOC-D, AOC-E, 3PTY
Specifies whether each ISDN or QSIG supplementary service is used.
The available services depend on the setting of Port Type on this screen.
When using the Centralised VM feature, set CF (Rerouting) to "No".
Value Range
For COLP, CLIR, COLR, CNIP, CONP, CNIR, CONR, CF (Rerouting), CT, CCBS, AOC-D, AOC-E:
No, Yes
For 3PTY:
No, Yes-3Pty
Maintenance Console Location
2.7.16 [1-1] Slot—PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
None
Feature Guide References
1.21.1.2 Calling/Connected Line Identification Presentation (CLIP/COLP)
1.21.1.3 Advice of Charge (AOC)
1.21.1.5 Call Forwarding (CF)—by ISDN (P-P)
212 PC Programming Manual