Panasonic KX-TDA100 Programming Manual page 109

3.
Click Yes to confirm.
The card will be removed.
To change the status (INS/OUS) of a card (Interactive mode only)
1.
Move the mouse pointer over the card.
A menu will be shown under the mouse pointer.
2.
Select the desired status:
• Click INS to set the card to in-service status.
• Click OUS to set the card to out-of-service status.
To install an option card on an OPB3 card
1.
Move the mouse pointer over the card.
A menu will be shown under the mouse pointer.
2.
Select Option Card.
The OPB3 Option Card Setup screen will be displayed. See 2.7.41 [1-1] Slot—OPB3 Option
Card Setup (KX-TDA100/KX-TDA200/KX-TDA600 only).
Supported Card Types
KX-TDA30
Card
MPR: Main Processing Card
DHLC4: Pre-installed Super Hybrid
Ports
DLC4: 4-Port Digital Extension Card
SLC4: 4-Port Single Line Telephone
Extension Card
BRI1: 1-Port BRI Card
BRI2: 2-Port BRI Card
LCOT2: 2-Port Analogue Trunk Card
LCOT4: 4-Port Analogue Trunk Card
DID3: 3-Port Analogue DID Card
DLC8: 8-Port Digital Extension Card
SLC8: 8-Port Single Line Telephone
Extension Card
IP-GW4: 4-Channel VoIP Gateway
Card
E1: E-1 Trunk Card
DPH2: 2-Port Doorphone Card
DPH4: 4-Port Doorphone Card
Maximum Supported Slot
Quantity Numbers
1 00
1 01
1
02–04 (Type A
Slots)
3
2
05–07 (Type B
Slots)
1
1
08–09 (Option
1
Slots)
2.7 [1] Configuration
Card Programming
2.7.3 [1-1] Slot—MPR Card Property
2.7.4 [1-1] Slot—Extension Card
Property
2.7.13 [1-1] Slot—BRI/PRI Card
Property
2.7.10 [1-1] Slot—LCO Card Property
2.7.30 [1-1] Slot—DID Card Property
2.7.4 [1-1] Slot—Extension Card
Property
2.7.10 [1-1] Slot—LCO Card Property
2.7.21 [1-1] Slot—E1 Card Property
2.7.43 [1-1] Slot—DPH Card Property
(KX-TDA30 only)
PC Programming Manual 109