Panasonic KX-TDA100 Programming Manual page 572

2.10 [4] Extension
Group CW w/o Tone (Ring after Call)
Enables an incoming call to an incoming call distribution group to arrive at a previously busy extension
at the moment that the extension goes on-hook for the previous call.
Value Range
Disable, Enable
Maintenance Console Location
2.10.1 [4-1-1] Wired Extension—Extension Settings
Programming Manual References
None
Feature Guide References
None
Extension Caller ID Sending
Enables the extension to send Caller ID information to an SLT.
Note that for KX-TDA30, the setting of this parameter is only effective when a resource for sending
extension Caller ID is assigned in Extension Caller ID Resource-1, 2 (KX-TDA30 only) for the port
in 2.8.18 [2-10] Extension CID Settings.
Value Range
Disable, Enable
Maintenance Console Location
2.10.1 [4-1-1] Wired Extension—Extension Settings
Programming Manual References
2.8.18 [2-10] Extension CID Settings—Extension Caller ID Resource-1, 2 (KX-TDA30 only)
Feature Guide References
1.18.1 Caller ID
Incoming Call Wait Timer for Extension Caller ID
Specifies the length of time that the ringing for a call is delayed when the call follows immediately after
the previous unanswered call. When receiving two calls in quick succession (e.g., when a call waiting
in a queue is directed to an extension immediately after the previous unanswered call stops ringing),
some SLTs require a pause, after the first call stops ringing, to receive the second call's Caller ID
information.
Note that for the KX-TDA30, the setting of this parameter is only effective when a resource for sending
extension Caller ID is assigned in Extension Caller ID Resource-1, 2 (KX-TDA30 only) for the port
in 2.8.18 [2-10] Extension CID Settings.
Value Range
0–15 s
572 PC Programming Manual