Removing And Installing Oil Pan - Skoda Octavia Workshop Manual

OCTAVIA
8 - Cap
9 - Retaining clamp
10 - Screw plug, 15 Nm
11 - Seal
♦ Cut open and replace if leaking
12 - 0.14 MPa oil pressure switch -F1-,
25 Nm
♦ Black
♦ Testing ⇒ page 17-5
13 - Seal
♦ Cut open and replace if leaking
14 - Oil filter holder
Edition 08.99
S00.5127.50.20
Lubrication System
15 - 15 Nm + torque a further ¼ turn (90°)
♦ Replace
16 - Gasket
♦ Replace
♦ Fit into lugs at oil cooler
17 - Oil cooler
♦ Ensure clearance to surrounding com-
ponents
♦ Pay attention to Note ⇒ page 17-1
18 - 25 Nm
19 - Oil filter
♦ Use tensioning strap for slackening
♦ Tighten by hand
♦ Pay attention to installation notes on
oil filter

Removing and installing oil pan

Special tools, testers and aids required
♦ Hinged wrench 3185
♦ Wrench socket 3249
♦ Hand drill with plastic brush attachment
♦ Flat scraper
♦ Torque wrench 5...50 Nm
(e.g. V.A.G 1331)
♦ Silicone sealant D 176 404 A2
Removing
K - Remove noise insulation panel in middle and
also on left and right -arrows-. Remove air
guides on outside first of all.
- Drain engine oil.
- Unbolt oil pan.
Note:
Use hinged wrench 3185 to slacken oil pan bolts
at flywheel side and unscrew with wrench socket
3249.
17
------------ 17-3 -------------