Skoda Octavia Workshop Manual page 140

26
------------ 26-6 -------------
¡ ¢ £ ¤ ¢ ¤ £ ¥ ¦ § ¨ ©       ¥    ¥ ¥  
Exhaust System
stress
Special tools, testers and aids required
♦ Torque wrench 5...50 Nm
(e.g. V.A.G 1331)
Procedure
l The exhaust system is aligned when cold.
K - To align the exhaust system, shop-make tool
from an M10 bolt to the dimensions stated.
♦ Dimension -X- = 4 mm
♦ Dimension -Y- = 25 mm
Note:
A second person is required for aligning the
exhaust system.
- Slacken bolted connections of clamping
sleeve between catalytic converter and front
silencer.
K - Insert shop-made tool through the rear hole
-arrow- of the tunnel bridge; the flat points
toward the hanger bolt of the exhaust sys-
tem.
Note:
The exhaust system is pretensioned in direc-
tion of travel when the shop-made tool is in-
serted.
OCTAVIA
Edition 08.99
S00.5127.50.20