Removing And Installing Oil Pan - Skoda Octavia Workshop Manual

17
¡ ¢ £
------------ ------------
Lubrication System

Removing and installing oil pan

Special tools, testers and aids required
♦ Hinged wrench 3185
♦ Wrench bit 3249
♦ Hand drill with plastic brush attachment
♦ Flat scraper
♦ Torque wrench 5...50 Nm (e.g. V.A.G 1331)
♦ Silicone sealant D 176 404 A2
Removing
K - Remove noise insulation panel -arrows-.
- Drain engine oil.
- Unbolt oil pan.
Note:
Use hinged wrench 3185 to slacken oil pan bolts
at flywheel side and unscrew with wrench bit
3249.
- Take off oil pan; detach with light blows with
rubber-headed hammer, if necessary.
- Use flat scraper to remove sealant residues
on cylinder block.
K - Use rotating plastic brush to remove sealant
residues on oil pan (wear eye protection).
- Clean sealing surfaces; they should be free
of oil and grease.
Installing
Notes:
♦ After applying the silicone sealant, the oil pan
should be installed within 5 minutes.
♦ Use wrench bit 3249 to fit on oil pan bolts at
flywheel side and tighten with hinged wrench
3185.
♦ A second person is required for installing the
oil pan.
OCTAVIA
Edition 08.98
S00.5104.52.20