Skoda Octavia Workshop Manual page 54

13
  
¨
Engine AZJ
¡ ¢ £ ¤
------------ -------------
¥
¦ § ¨ © ¦ 
¥
¥
Crank Assembly
10 Conrod bolt
♦ replace together with nut, item 5
11 C
12 Piston pin
♦ if stiff, heat piston to 60 °C
♦ use drift VW 222 A for removing and
installing
¥
Note:
¥
For carrying out removal and installation opera-
tions, attach engine with engine holder MP
1-202 and spacer sleeves T30010 to repair
stand MP 9-101.
1 Piston rings
♦ offset ring joints by 120°
♦ use piston ring pliers for removing and
¥
installing
♦ marking “TOP” faces piston crown
♦ 2-part oil scraper ring
♦ inspecting gap clearance ⇒ Fig. 1
♦ inspecting end clearance ⇒ Fig. 2
2 Piston
♦ inspecting ⇒ Fig. 3
♦ mark installation position to conrod
and matching cylinder with waterproof
felt pen
♦ arrow on piston crown points toward
belt pulley side
♦ ∅ of piston = 82.465 mm
3 Piston pin
♦ if stiff, heat piston to 60° C
♦ use drift VW 222 A for removing and
installing
OCTAVIA
Edition 01.02
S00.5127.53.20