Skoda Octavia Workshop Manual page 16

10
------------ 10-8 -------------
Removing and Installing Engine
- Unplug connectors:
-
-
K - Remove slave cylinder -arrow- and place
down to the side, secure with wire. Do not
open line system.
Note:
Do not depress clutch pedal.
Models with automatic gearbox
K - Use a screwdriver to press off selector lever
cable -1- at selector lever of gearbox -4-. Pull
off securing clasp -3- at support bracket.
- Take off selector lever cable and place to
the side.
K - Unplug the following connectors:
1 - to solenoid valves (10-pin connector)
2 - to vehicle speed sender -G68-
3 - at multifunction switch -F125-
4 - at gearbox speed sender -G38-
- Unbolt bracket for pressure line -5- of power
steering and gearbox support.
- Detach wiring loom from the fixtures and run
out to the side.
at vehicle speed sender -G68-
at reversing light switch -F4-
OCTAVIA
Edition 08.99
S00.5127.50.20