Skoda Octavia Workshop Manual page 44

13
¡ ¢ £
------------ -------------
Crank Assembly
K - Oil threaded head of seal extractor MP
1-226 and screw as far as possible into the
seal using considerable pressure.
- Slacken knurled screw and turn inner part
against the crankshaft until the seal is pulled
out.
Installing
Notes:
♦ Pay attention to different seal versions
⇒ page 13-14, Fig. 1.
♦ Never install an elastomer seal (old version)
if a PTFE seal (new version) was installed.
♦ It is permitted to install a PTFE seal in order
to replace an elastomer seal.
Installing elastomer seal
- Inspect crankshaft for signs of wear.
- Apply a thin film of oil to the sealing lip of the
seal.
K - Fit guide sleeve from MP 1-314 onto the
crankshaft journal.
- Push seal over guide sleeve.
K - Press seal in as far as the stop with pres-
sure sleeve MP 1-231/1. Use old central bolt
of crankshaft toothed belt sprocket for this
step.
OCTAVIA
Edition 01.02
S00.5127.53.20