Skoda Octavia Workshop Manual page 134

26
12 - Front exhaust pipe with catalytic con-
verter
♦ to remove, separate plug connection
for lambda probe -item 10- and take
cable out of fixtures
♦ testing catalytic converter
⇒ page 26-8
13 - 40 Nm
♦ replace
♦ before inserting, coat with hot bolt
paste „G 052 112 A3“
14 - 25 Nm
Engine code AZJ
1 - Heat shield
2 - Lambda probe 1 upstream of catalytic
converter (G39), 50 Nm
¡ ¢
♦ coat only thread with hot bolt paste
“G 052 112 A3”; hot bolt paste must
not get into the slot of the probe body
♦ use lambda probe wrench (e.g. 3337)
for removing and installing
3 - 10 Nm
4 - 25 Nm
5 - 25 Nm
♦ replace
------------ -------------
Exhaust System
15 - Brace
16 - Gasket
♦ replace
♦ pay attention to installation position:
slot for lambda probe points to the rear
17 - Exhaust manifold
♦ removing and installing ⇒ page 26-3
18 - Heat shield
6 - Connecting pipe
♦ for secondary air injection system
7 - Bolted connection, 35 Nm
8 - Exhaust manifold
9 - Gasket
♦ replace
10 - Front exhaust pipe with catalytic con-
verter
♦ with compensation element
11 - Lambda probe 2 downstream of cata-
lytic converter (G130), 50 Nm
♦ coat only thread with hot bolt paste
“G 052 112 A3”; hot bolt paste must
not get into the slot of the probe body
♦ use lambda probe wrench (e.g. 3337)
for removing and installing
12 - 10 Nm
13 - Protective plate
♦ for catalytic converter
14 - 10 Nm
15 - Securing nut
16 - Supporting plate
17 - 25 Nm
18 - 40 Nm
♦ replace
19 - Gasket
♦ replace
OCTAVIA
Edition 01.02
S00.5127.53.20