Skoda Octavia Workshop Manual page 77

OCTAVIA
Edition 08.99
S00.5127.50.20
¤ ¥ ¦ § ¨ ©   
    ! "
Cylinder Head/Valve Gear
l Cylinder head installed
)  0 # 1 2 3
♦ Puller MP 1-206
♦ Pressure hose MP 1-210
♦ Assembly lever MP 1-211
♦ Insertion tool MP 1-212
♦ Assembly device MP 1-213
♦ Spark plug wrench (e.g. 3122 B)
♦ Assembly tool T10029
- Remove camshaft ⇒ page 15-16.
- Remove bucket tappets (do not mix up) and
place down with contact surface facing down.
- Use assembly tool T10029 to unplug the
spark plug connectors and use spark plug
wrench (e.g. 3122 B) to remove the spark
plugs.
- Position piston of the relevant cylinder to ”bot-
tom dead centre”.
K - Insert assembly device MP 1-213 and set
mounting to height of stud bolt.
- Screw pressure hose MP 1-210 into the
spark plug thread and constantly apply pres-
sure to the cylinder.
min. 0.6 MPa
- Use assembly lever and thrust piece MP
1-211 to remove valve springs.
Note:
If valve collets are tight, detach by striking the
assembly lever lightly with a hammer.
 ¥ ¨ § 
  ¥ 
# # " $ % ( $
&  ' $
 $ !
valve
t t and
15
required
¡ ¢ £
------------ 1 -------------