Lubrication System Page; Removing And Installing Parts Of The Lubrication System - Skoda Octavia Workshop Manual

OCTAVIA

Removing and installing parts of the lubrication system

Engine codes AEG, APK, AQY and AZH
Notes:
♦ If considerable quantities of metal swarf, or
abrasion are found in the engine oil when
carrying out engine repairs, it is then neces-
sary to carefully clean the oil galleries and,
in addition, to replace the oil cooler in order
to avoid consequential damage.
♦ The engine oil level must not extend beyond
the max. marking - risk of damage to cata-
lytic converter!
Oil quantity and oil change:
⇒ Inspection and Maintenance
Oil specification:
⇒ Inspection and Maintenance
Edition 01.02
S00.5127.53.20
Lubrication System
1 - Oil pump
♦ with pressure relief valve 1.2 MPa (12
bar)
♦ before installing, check whether the
two dowel sleeves for centering oil
pump/cylinder block are present
♦ if scoring is present on the contact
surfaces and gears, replace pump
2 - Chain sprocket for oil pump
♦ pay attention to installation position
♦ can be fitted onto the oil pump shaft
only in one position
3 - 25 Nm
4 - Chain for oil pump
5 - Sealing flange
♦ insert with silicone sealant „D 176 404
A2“ ⇒ page 13-18
♦ replace crankshaft seal
⇒ page 13-15
6 - 15 Nm
7 - Chain tensioner, 15 Nm
♦ when installing, pretension spring and
attach
8 - Chain sprocket
9 - Dipstick
♦ oil level must not extend beyond the
max. marking!
♦ inspecting engine oil level ⇒ Inspec-
tion and Maintenance
10 - Filler funnel
♦ detach for extracting oil
11 - Guide pipe
12 - Oil spray nozzle
♦ for cooling piston
13 - Pressure relief valve, 27 Nm
♦ opens at 0.25...0.32 MPa (2.5...3.2
bar)
♦ insert without sealant
14 - O-ring
♦ replace
15 - Suction line
♦ clean strainer if soiled
17
------------ 17-1 -------------