Skoda Octavia Workshop Manual page 50

13
------------ 13-22 -------------
Crank Assembly
K - Check installation dimension in three points
of the drive plate and determine mean value.
♦ Specified value
dimension -a-: 19.5….21.1 mm
Note:
The measurement is made through the hole of
the drive plate to the milled surface of the cylin-
der block.
If the measurement is less than the specified
value:
K - Once again remove drive plate and repeat
measurement with compensating washer
-1-.
If the specified value is reached:
- Lock drive plate with counterholder MP
1-221 and tighten the new bolts -3- to 60 Nm
and torque a further 90° (¼ turn).
OCTAVIA
Edition 04.03
S00.5127.54.20