Skoda Octavia Workshop Manual page 10

10
------------ 10-2 -------------
Removing and Installing Engine
♦ It is recommended to use the pliers for spring
strap clamps for removing and installing such
clamps.
♦ Ensure the connectors are correctly as-
signed; mark if necessary.
Procedure
- On models fitted with coded radio set, pay
attention to coding; determine if necessary.
- Switch off ignition (if not already off) and dis-
connect earth strap of battery.
K - Remove engine trim panel -2-.
Slacken nut -1- for this step, withdraw dip-
stick -3- and remove trim panel by pulling it
up at the front with a jerk (arrows).
- Detach secondary air injection pump to-
gether with bracket ⇒ page 26-10.
- Raise vehicle with a lift platform. Pay atten-
tion to the following points:
K - The arms of the lift platform must be posi-
tioned only below the longitudinal members.
Warning!
The arms must on no account be positioned be-
low the sill, or the front and rear axles.
K - The two front jacking points are located at
the front of the two side members at the level
of the marking on the sill.
Warning!
Never start the engine and engage a gear when
the vehicle is raised so long as only one driven
wheel is still touching the ground.
OCTAVIA
Edition 08.99
S00.5127.50.20