Skoda Octavia Workshop Manual page 36

13
¡ ¢ £
------------ -------------
Crank Assembly
Installing toothed belt
Note:
When the camshaft is rotated, the crankshaft
must not be positioned at TDC otherwise there
is a risk of damage to the valves and piston
crowns.
Requirement
l The piston must not be positioned at top dead
centre.
K - Align marking on camshaft sprocket with
marking on toothed belt guard (TDC of cyl.
1).
- Fit toothed belt onto toothed belt sprocket of
crankshaft and coolant pump (pay attention
to direction of running).
- Bolt on engine support at cylinder block.
Tightening torque: 45 Nm
Note:
Insert bolts into engine support before install-
ing.
- Install centre and bottom parts of toothed belt
guard. Replace bolts.
Tightening torque: 10 Nm
- Install belt pulley/vibration damper.
Tightening torque: 40 Nm
- Align marking on vibration damper with mark-
ing on bottom part of toothed belt guard (TDC
of cyl. 1).
K - Check whether TDC marking of flywheel/
driven plate and reference mark are aligned
-arrow-.
I - Manual gearbox
II - Automatic gearbox
- Install engine mount, replace bolts.
Aligning unit mounting for engine ⇒ page
10-15.
Tightening torques ⇒ page 10-16
- Take off supporting device MP 9-200.
OCTAVIA
Edition 08.99
S00.5127.50.20