Skoda Octavia Workshop Manual page 74

15
¡ ¢ £
------------ -------------
           !
Cylinder Head/Valve Gear
Removing and installing
♦ Torque wrench 5...50 Nm
(e.g. V.A.G 1331)
♦ Torque wrench 40...200 Nm
(e.g. V.A.G 1332)
♦ Counterholder T30004
♦ Sealant AMV 174 004 01
Removing
- Remove engine trim panel ⇒ page 10-2.
- Take off top part of intake manifold ⇒ page
15-3.
Notes:
♦ The coolant hoses remain connected at the
throttle valve control unit (unbolt throttle valve
control unit, if necessary).
♦ Seal off intake passages with clean cloths.
- Remove top part of toothed belt guard.
K - Rotate crankshaft and position crankshaft
sprocket to TDC marking of cyl. 1. Marking
on camshaft sprocket must be aligned with
arrow on toothed belt guard.
- Slacken tensioning pulley and take off
toothed belt.
- Turn back crankshaft slightly.
K - Remove camshaft sprocket.
Hold camshaft sprocket tight with counter-
holder T30004 to slacken the bolt (unscrew
bolts -arrows- first of all).
- Remove parallel key from the camshaft.
- Remove cylinder head cover.
- Remove bearing caps 5, 1 and 3 first of all.
Slacken bearing cap 2 and 4 alternately di-
agonally across.
¤ ¥ ¦ § ¨ ¥ © 
"  # $  "  %
testers and aids
OCTAVIA
Edition 08.99
S00.5127.50.20